Maximum drawdown describes the largest decline from an earlier peak to a subsequent trough in the series being measured. To interpret the number, first identify that series and the method used to observe it.

An account-equity series, a closed-trade balance series and an intrabar calculation may capture different paths. Do not assume that two reports use the same convention simply because both label a number “maximum drawdown.” TradingView’s intrabar documentation illustrates one implementation; it is not a description of TradeLab’s calculation.

Find the peak before the decline

A percentage drawdown compares a decline with the relevant earlier peak. It is different from comparing the latest value with the starting value.

Consider this entirely hypothetical equity sequence, in currency units, with no deposits or withdrawals:

ObservationEquityRelationship to the earlier peak
A100,000Starting observation
B120,000New peak
C90,000Trough after that peak
D110,000Partial recovery

The decline from B to C is 30,000. Dividing that decline by the 120,000 peak gives a 25% drawdown. The final observation is still 10% above the starting observation, but that endpoint comparison does not describe the decline experienced along the way.

These figures demonstrate arithmetic only. They are not market data, a TradeLab test, an expected return or evidence for a trading strategy.

Check the denominator

For the illustrated decline:

Drawdown percentage = (earlier peak − later trough) ÷ earlier peak × 100.

This percentage calculation assumes a positive earlier peak. If the peak is zero or negative, use the reporting system’s documented convention rather than applying this formula.

Dividing by the trough instead answers a different question. Moving from 90,000 back to 120,000 requires a gain of approximately 33.3% from the lower value. That recovery calculation is not the 25% peak-to-trough drawdown calculation.

Keep amount and percentage separate. A report in currency units should identify the currency and series; a percentage needs a clear denominator and calculation convention.

Ask which observations the report includes

A useful report description should explain whether open-position gains and losses are included, how often the series is observed and how cash flows and costs are treated. An intrabar approach may consider information that is absent from an end-of-period series.

When comparing reports, keep the test period, data, sizing and observation method together. If the methodology is unavailable, label that limit rather than assuming two values are directly comparable.

The broader backtest validation guide provides a place to check those assumptions alongside the test specification and evidence.

Read drawdown beside the rest of the test

A drawdown figure does not explain which trades, exposures or assumptions produced the path. Review the underlying observations and the position-sizing rule. Check whether the result depends on a narrow period, a small number of trades or concentrated outcomes.

A short historical series can contain only the events that occurred within it. The sample-size guide and out-of-sample guide address different parts of that evidence question.

Keep the historical limit explicit

Historical maximum drawdown is not a ceiling on future losses. It is a description of the measured path under the stated assumptions. This article does not prescribe an acceptable drawdown, recommend a strategy or predict future performance.

Trading involves substantial risk, including possible loss of capital. Backtests do not predict future results. TradeLab does not provide financial advice or guarantee performance.